Pre- and post-padding reset

Started by IanL-S, February 20, 2023, 08:34:55 AM

Previous topic - Next topic

IanL-S

I changed the pre- and post padding in the PVR settings, and worked as expected. This morning I noticed that timers for recently set recordings had the default 3/30. Changed them back to 15/40. Hopefully this is a one-off.

Has anyone else had this happen?
IceTV: IceBox + BYOB IceBox + 2xTRF-2400 + 2xTF7100HDPVRtPlus + SKIPPA [RIP] + T2 + U4 + V2
No IceTV: a few Toppys and T2
Synology NAS
Check out the oztoppy wiki and oztoppy Forum for Toppy help

IanL-S

#1
Found the location of what I beleive is the master setting, which is accessed using the TVheadend configuration portal - found at http://{Your IceBox IP Address}:9981:
IceTV IceBox defaults c.png

Recordings scheduled on the IceBox itself use the pre-/post value set in the DVR/Live TV > Recordings settings.

This is the current situation, it may change in the future.

At this stage I am unsure if the TVheadend setting survives an update in the IceTV add-in.
IceTV: IceBox + BYOB IceBox + 2xTRF-2400 + 2xTF7100HDPVRtPlus + SKIPPA [RIP] + T2 + U4 + V2
No IceTV: a few Toppys and T2
Synology NAS
Check out the oztoppy wiki and oztoppy Forum for Toppy help

Ian_AW

The way it works now is that for timers set via the IceBox, the settings set in PVR - TV are used.

For timers set via IceTV and sent to the IceBox, they use the settings in TVHeadEnd.

The TVHeadEnd values do revert to the original values of 3/30 for an update, however That may be because of the way the modules are supplied in the update and the values set in it.