IceTV Forum

IceTV Guide for IceTV enabled PVRs => Windows Media Center => Topic started by: benjfree on October 17, 2006, 09:57:46 PM

Title: missing end of recorded programs
Post by: benjfree on October 17, 2006, 09:57:46 PM
Hi ,
I have set up the Ice  Guide and it all seems well and good but channel 10 and nine seem to run overtime all the time in primetime hours 830 - 1030 and if i set something to record it cuts the end of the program off.
i have set media centre to record extra time after the program finishes but the maximum time is 4 mins which still means that i miss about 5 mins of the program..

any ideas on how to get the full program into 1 recording without recording the following show just to get the ending of the first one ?

Thanks
Ben
Title: Re: missing end of recorded programs
Post by: Paul on October 18, 2006, 06:08:16 AM
I don't use media center, but a clumsy but workable solution may be to record the program afterwards as well?

Paul.
Title: Re: missing end of recorded programs
Post by: benjfree on October 18, 2006, 08:22:14 AM
i just logged into my account on ice and the EPG data is correct (Melbourne) (im in Bendigo) but the timezone was set to Perth. I changed it to Melbourne. Do You think this could have been the problem... What is the time zone option for in (my account)
Title: Re: missing end of recorded programs
Post by: Normm on October 18, 2006, 10:33:48 AM
You should be able to use the Advanced Record function to allow an extra 15mins recording after a show. ;)
Title: Re: missing end of recorded programs
Post by: benjfree on October 18, 2006, 08:55:23 PM
thanks, that will get me out of trouble.
it would be good in 10 and 9 are actually on time
Title: Re: missing end of recorded programs
Post by: Shane on October 19, 2006, 04:01:03 PM
Hi,

Ice have recently released a new beta version of PIMP for MCE that supports soft pre and post padding. So far this has worked well for me, and has my recordings going for an additional 8-12 mins past the scheduled time with no additional settings in MCE required.

This should fix your problem.

See here:
http://www.icetv.com.au/index.php?topic=432.0

Regards,
Shane.