hi folks, first time for me on this forum. i recently subscribed to icetv and believe i have set it all up correctly. i am getting epg updates but when i try and do a remote record (from an imac) even though the tv guide indicates that it will be recorded it doesn't send the message to my beyonwiz. any ideas. thanks .elvis
Was the icon on the recording a "queued" icon ((http://www.icetv.com.au/images/remoteicons/remote_rec_queue.png) or (http://www.icetv.com.au/images/remoteicons/remote_recseries_queue.png)) or a "scheduled" icon ((http://www.icetv.com.au/images/remoteicons/remote_rec.png) or (http://www.icetv.com.au/images/remoteicons/remote_recseries.png))?
It can take up to 30 minutes for recordings to be sent to the Beyonwiz? Has it fixed itself now?
aagh, patience. you were dead right. it is working beautifully now. thankyou. one more point - does the unit have to be turned on for the "booking" to go through. i know that with my foxtel iq, you don't have to have it on when remote recording. thanks again. elvis.
Quote from: elviswallman on September 15, 2009, 01:39:06 PM
aagh, patience. you were dead right. it is working beautifully now. thankyou. one more point - does the unit have to be turned on for the "booking" to go through. i know that with my foxtel iq, you don't have to have it on when remote recording. thanks again. elvis.
When the Beyonwiz is in standby, it's almost completely off; no power to the main board or the HDD, only the front panel is powered. So there's no way for IceTV (EPG or recordings) to be updated when it is in standby. When you start the Beyonwiz out of standby it loads its EPG from a HDD cache and its timers from its config flash, then attempts to synchronise with IceTV. If it's been more than 30 minutes since it last contacted Beyonwiz, the update will normally succeed, otherwise it will try to update update when 30 minutes from the last update attempt has passed.
The IQ can update in standby because the IQ is almost completely on in standby, rather than being almost completely off.
A simple way to regularly refresh the data while you are out/at work and the device is off is to set a daily repeating non-recording timer to turn it on for about five minutes, perhaps at midday or mid afternoon, so you can programme remotely, confident it will refresh its EPG and timer data then go back to power saving mode until required to wake and record.