Beyonwiz AP-U1 Universal Remote tutorial?

Started by PLANT, July 08, 2026, 12:55:30 PM

Previous topic - Next topic

PLANT

So I have the original Beyonwiz AP-U1 and cannot find any youtube video on it?
I typed in google AI to place a new code in the remote for my aircon unit but it does not hold the new codes I have attempted below 5999?
Anyone have further information or have and used this remote to change the A\C code?

Regards


PLANT

Thankyou for the link.
I actually have the original manual that I had a quick look at....
Now I have an EMAILAIR air con...it's not listed in the back pages of manual.
But I googled the code and the issue is I cannot get it to stick in the controller?
Will review manual again tomorrow and see if I can see what will SAVE the code.

Anyone have any experience?

PLANT

So I reviewed the official documentation.
No codes for EMAILAIR aircon are listed in the back of book.

I initially got the remote in search auto mode and placed it near air con receiver in roof....I gave up as it started at 5000 and when up by one at a time.

I then attempted as per instructions to enter all GOOGLE AI codes that the Emailair uses but none stuck/saves in the remote.

I attempted the "other" code and it saved but did not turn on/off the aircon.

To cold to continue tonight... But a complete auto search where it beeps and I believe send an IR but not required to be pointed up at receiver.... Might try tomorrow.

Any other input from anyone?

prl

Quote from: PLANT on July 12, 2026, 05:38:58 PMNo codes for EMAILAIR aircon are listed in the back of book.

The AP-U1 is old, and it sounds like it never had codes for EMAILAIR air conditioners. When I did a Google search for EMAILAIR, a couple of places selling remotes for EMAILAIR air conditioners came up. That may be more fruitful than trying to get your AP-U1 to work.
Peter
Beyonwiz T4 in-use
Beyonwiz T2, T3, T4, U4 & V2 for testing

PLANT

I pointed the remote towards sensor in AUTO SEARCH mode... It went from 5000 to 5400 without finding the code.
It then went back to 5000?
This has codes to 5999???

Not looking good 🤬

prl

Quote from: PLANT on July 13, 2026, 01:55:30 PMThis has codes to 5999???

Are you sure that it has all those codes, if the automatic scan only went from 5000 to 5400? Does the paper manual list any codes between 5401 and 5999 (I can't find my copy, and the PDF version that blip pisted a link to doesn't have a code list)?
Peter
Beyonwiz T4 in-use
Beyonwiz T2, T3, T4, U4 & V2 for testing

PLANT

I'll  need to check the list as I was going off when you turn remote on it says 5999...