Main Menu

Icebox tuners

Started by dmart, July 14, 2023, 04:32:25 PM

Previous topic - Next topic

dmart

Considering getting an dual tuner icebox for my caravan. A couple of questions:

1. Assuming tuners are external to device (usb), what is there physical size? Need to fit box on a small shelf or in a small cupboard.

2. If the internet is not available, can the icebox access the standard tv epg?

DeltaMikeCharlie

The USB tuner device that IceTV shipped me is approximately 74mm x 30mm x 15mm.  However, there is a USB cable to plug in at one end and an antenna cable to plug in at the other end.  Both of these plug in on the 30x15 ends and once attached, extend the unit to about 140mm before the cables become flexible enough to meaningfully redirect.

I did manage to get Free-to-air EPG working on the IceBox, but this is really not its intended mode of operation and is not all that straight forward.  I also ended up with double the channels, one set with ICE EPG and one set with FTA EPG.

I suppose that from this point, it would be possible to create two modes 'home' and 'caravan' whereby only the channels appropriate for those modes are activated and visible.  However, as you travel, you may have to retune often.

Even if you did have internet access while travelling, having to retune your channels could also have a flow-on effect to your ICE configuration.  The ICE EPG comes in 'regions'.  If you travel from, say, a capital city to a rural area, 'Channel 7' becomes 'Prime', etc, so you would have to change your ICE region to be able to get the correct EPG as well as retuning your channels.

On the plus side, the IceBox is powered by a wall wart that provides DC to the unit.  If you were to be totally off-grid, then you would not have to worry about an inverter and could probably run the IceBox off solar/batteries with the right adapters.

ICE TV staff may have better ideas.

IanL-S

#2
Another approach would be to install standard LibreELEC 11 on the PC then install a PVR addon such as TVHeadend.

In early beta testing we had to manually configure TVHeadend for IceTV, presumably it is possible to do the same with free-to-air EPG. You just need to know the EPG grabber to use. You would have to check the TVHeadend wiki for guidance on that. Just found necessary information here. The thread has not been updated for four years.
IceTV: IceBox + BYOB IceBox + 2xTRF-2400 + 2xTF7100HDPVRtPlus + SKIPPA [RIP] + T2 + U4 + V2
No IceTV: a few Toppys and T2
Synology NAS
Check out the oztoppy wiki and oztoppy Forum for Toppy help

raymondjpg

#3
Quote from: IanL-S on July 15, 2023, 09:26:25 AMYou just need to know the EPG grabber to use. You would have to check the TVHeadend wiki for guidance on that.
In my experience it is the FTA grabber that is enabled by default in any vanilla installation of LibreELEC/TVHeadend. I was able to configure these installations to use the IceTV xmltv feed and grabber, but only after some assistance from IceTV support, and last time I looked it didn't appear to be working any more.
Beyonwiz T2, Beyonwiz U4, IceBox BYO with Hauppauge WinTV-dualHD (x2), Hauppauge WinTV-quadHD