Up until about a day and a half ago the EPG on my Topfield 2460 showed up properly but now it doesn't show at all. I am in Melbourne and the Topfield 2460 is permanently hardwired to my network and can be seen on my network, but no EPG is displayed on my Topfield.
Is it a problem at my end or at IceTV?
Thanks for your help.
The most likely cause of the problem is the Toppy (I have several that use IceTV).
The fact that the EPG is completely empty suggests that the Toppy had an unscheduled shut-down and did not have the opportunity to cache the EPG data.
I assume that you have checked that the Toppy is still logged into the IceTV server. Do you use IceTV Interactive to set timers, or do you set them on the Toppy?
You could try Menu, Installation, System Recovery, Reset Service List. The do a Service Scan, then go into settings and 'reactivate' IceTV. The go to the IceTV Iterative www site and resend all timers for the Toppy. The Toppy checks in with IceTV every 15 minutes, and does EPG data fetches and Timer Updates in alternate fetches. Usually the EPG data appears immediately, and it may take a short time for Timers to be downloaded. If nothing appears after 15 minutes, turn the Toppy off and then turn it on again.
Ian
Quote from: rll on January 14, 2016, 07:44:33 AM
Up until about a day and a half ago the EPG on my Topfield 2460 showed up properly but now it doesn't show at all. I am in Melbourne and the Topfield 2460 is permanently hardwired to my network and can be seen on my network, but no EPG is displayed on my Topfield.
Is it a problem at my end or at IceTV?
It's at your end. Is your IceTV subscription still active?
Recent, post 2011, Topfield firmware versions require rebooting the Topfield once a fortnight or once a week to keep IceTV running.
Older, pre-2011, firmware required leaving the Topfield on 24/7.
Even though your Topfield is visible on your network check the Topfield can still access the Internet. Try the Portal in the Entertainment menu.
Then check IceTV is still enabled on the Topfield.
If IceTV is already enabled, follow Ian's steps to clear and rescan the channels, re-enable IceTV and resend all recordings. Clearing the channels resets the IceTV account settings so you will need to enter your user id and password again.
Thanks for the comments.
I switched the power to the PVR off and the on again and all is now good. I was a bit surprised it was that easy as I wasn't looking forward to resetting everything. I am using the August 2014 firmware and was unaware that the Toppy needs rebooting every couple of weeks.