Good Morning,
I have installed the IceBox update and I thought that might resolve my two issues, but no!
Often, when accessing the IceBox from my Samsung TV, there is no sound on videos and the soft click usually heard when moving the pointer is also missing. The only resolution to this (that I have found) is to reboot the IceBox. A but messy but it resolves the problem. This problem has been there since my original installation a few months ago.
The other issue is that, sometimes, when moving the pointer, the pointer makes multiple skips making it hard to select the required option.
Apart from these two problems, the recording and playback features are good although there seems to be additional padding at the start even though I have set the default to 1 minute.
Russell
Hi Russell,
To sort out the sound issue you need to check that your Samsung TV is selected. Go to System > Audio > Across to "Audio Output Device". You should see the TV listed in the rather confusing list "ALSA: Intel PCA ..Samsung xxx"
It is described in our online setup guide under "TV settings on the IceBox".
I would advise against using the remote pointer unless you have a touchpad. Just use the up, down, left and right functions of the remote.
The IceBox is pre-configured with 3 minutes pre-padding and 30 minutes post padding. That can't be varied at the moment but we'll soon do an online software update to do so, although those settings are what we would always advise, especially with four tuners.
Using cursor with IceTV RCU can be messy - not limited to the IceTV RCU as I have had similar issues with other Kodi "compliant" RCUs. I have a Logitech Bluetooth keyboard with trackpad and the trackpad works well.
Ian
Thanks for the replies and suggestions.
The only way that I could select the TV for sound was to turn off the soundbar, and then the TV was listed on HDMI #0 on the IceBox. I turned the soundbar back on and left the audio set to HDMI #0 and on checking there was no reference to the TV speakers on the IceBox. However there was sound. I left the IceBox running for 24 hours, or so, while I went back to watching normal TV. When I later selected the IceBox the sound was missing. My only remedy is to reboot the IceBox! I am assuming it is OK to leave the IceBox running.
Regarding the crazy pointer movements, I only use the arrow keys on the remote.
Any further suggestions would be welcome.
Russell
No issue with keeping in running 24/07 other than the added ware caused by time-shift (but doubt it will be significant). I usually have time-shift disabled on PVRs other than my Topfield 7100+ which out of habit I use as my primary PVR.
Good Morning,
I think I have solved the problem of the missing sound. My solution was to prevent the IceBox from going to sleep (setting the time to start sleeping to zero) and therefore leaving it in the Idle state. So far, this has worked for two days so I am hopeful this is a long-term solution!
Russell
We always advise that PVRs are left on as sleep has always caused reliability issues. The power consumption in its idle non-recording state is negligible.