IceTV Forum

IceTV IceBox => Getting Help => Topic started by: Ian_AW on June 19, 2023, 04:26:13 PM

Title: How to set the IceBox to WiFi after it was previously using Ethernet?
Post by: Ian_AW on June 19, 2023, 04:26:13 PM
G'day,

After getting my Beyonwiz T2 working, I decided to set it as the main PVR. Also, my IceBox was a little unreliable. As a result, I transferred the Ethernet cable from the IceBox back to the Beyonwiz.

No problem so far as both units functioned correctly, the T2 on Ethernet and the IB on  Wi-Fi.

Because of lock ups with the IB, I decided to do the 10+ hour removal of power, only now the IB cannot connect via Wi-Fi. There is no sound and no content other that had had been recorded, but no sound - even from the RCU movements.

How can I change the network connection settings? I have searched high and low but no luck. The settings shows the IP Address as 127.1.1.1 which is a local host pointer back to itself.

A Communications failed message pops up in the top right.

Any info would be appreciated.

Thanks.
Title: Re: How to set the IceBox to WiFi after it was previously using Ethernet?
Post by: MD on June 19, 2023, 04:39:31 PM
Hi Ian,

My advice is to do a soft reset when you can reset/set its network connection. There maybe a short communication failed message for a couple of seconds max which are then replaced by a connection message as the software syncs up.
Title: Re: How to set the IceBox to WiFi after it was previously using Ethernet?
Post by: Ian_AW on June 19, 2023, 05:25:49 PM
Thanks. I'll give it a go.
Title: Re: How to set the IceBox to WiFi after it was previously using Ethernet?
Post by: MD on June 19, 2023, 05:29:51 PM
I should have added that a soft reset will also upload our latest IceTV add on software v1.0.44 which we believe will solve the freezing/read only SSD problems.