IceTV Forum

IceTV IceBox => General => Topic started by: JD0410 on March 19, 2023, 06:13:22 PM

Title: No IP address
Post by: JD0410 on March 19, 2023, 06:13:22 PM
I switched the TV on earlier and in the TV tab there was a message...PVR manager is starting up 0%
I checked on this forum and as suggested i tried a soft reset, no change, i tried a hard reset still no change. i checked the system screen and there is no IP address showing.
With either the soft or hard reset it didn't go into a full install and config.
When the last screen appears and asked you to wait 30 seconds for the setup to continue, nothing else happens, If i go into the TV tab the PVR Manager message is still going around.
I thought a hard reset would have taken the system back to a blank insatll and i would have to do a channel scan etc
Any suggestions on what the solution may be
Title: Re: No IP address
Post by: MD on March 19, 2023, 07:04:20 PM
Try pulling out its power pin and leaving it for at least five minutes to fully discharge.  Then plug it back in and turn i on and it should run its setup again, hopefully with no problems.
Title: Re: No IP address
Post by: JD0410 on March 20, 2023, 10:06:31 AM
I removed the power lead and waited 30 minutes, when i reconnected it the icebox started with a large ICEBOX logo, then the menu screen opened and a message appeared in the top right corner 'Remote communication server failed to start' When i go into the system screen there is still no IP address showing, and the PVR manager is starting up 0% is showing
The system is using a wifi connection, which is working on my phone when i check the signal strength next to the Icebox,
Any other suggestions please
Title: Re: No IP address
Post by: Daniel Hall at IceTV on March 20, 2023, 01:37:52 PM
Looking at this and the PVR manager not starting up, this is what is expected if the network connection is not established during the initial setup process as there are a few updates that occur directly after the initial system setup before the IceTV wizard starts.

Not getting an IP address through the setup is not a good sign, and even after that not showing an IP address on the system screen shows the same issue that the network is not connected.

At this point it might be worth doing one more hard reset so the initial setup wizard comes up again, and ensuring that you don't go past the network setup until an IP address is shown on that page.
Title: Re: No IP address
Post by: JD0410 on March 20, 2023, 02:33:21 PM
Problem solved...
When going through the setup i noticed that the telstra modem was showing as 'idle' i scrolled up and selected the modem, it asked for the password, after entering the password the IP address was displayed and the setup process continued as you would expect and did the full station scan etc.
Still don't know why it happened, but all good now
Thanks for the suggestions