I haven't received the usual email from IceTV about the upcoming DST change tomorrow 1 April at 03:00.
IceTV has a support item (http://support.icetv.com.au/entries/21199873-daylight-savings-what-do-i-need-to-do-when-daylights-savings-starts-or-ends) about what you need to do about it, for all supported recorders.
Quote from: prl on March 31, 2012, 12:16:58 PM
I haven't received the usual email from IceTV about the upcoming DST change tomorrow 1 April at 03:00.
IceTV has a support item (http://support.icetv.com.au/entries/21199873-daylight-savings-what-do-i-need-to-do-when-daylights-savings-starts-or-ends) about what you need to do about it, for all supported recorders.
Received an email 5PM friday, with the same link .
I recieved an email from IceTV at 4.47pm on 30 March 2012 covering the DST implications
You might want to check your junk filter / spam mailbox to see if it's there
Quote from: bodogbodog on March 31, 2012, 03:26:51 PM
I recieved an email from IceTV at 4.47pm on 30 March 2012 covering the DST implications
You might want to check your junk filter / spam mailbox to see if it's there
I use POP to get my mail and I have spam filtering set to "tag and keep" with my email provider (Yahoo). I checked anyway, and there wasn't anything in my Webmail Spam folder or anything recent from IceTV in my Trash Webmail folder. Occasionally it takes an unreasonable amount of time (more than a day) for messages to get delivered to my inbox.
I found that my XML data was still out this morning (I deleted all data & re-downloaded in ForTheRecord). I switched to the OTA EIT to make sure this mornings recordings went off OK, but channel 10 is out on that. :o
I'll give it the chance to flush through & try again this afternoon.
On my Beyonwizes, with NETWORK time and the new instructions for the DST changeover from IceTV, I've had the simplest and smoothest DST transition so far!
NETWORK time, of course, because apparently the TV networks still can't all get their broadcast time correct (http://www.beyonwiz.com.au/phpbb2/viewtopic.php?p=96073#96073). Even though the broadcast time is in UTC and doesn't change with the DST changeover.
Quote from: prl on April 01, 2012, 09:50:19 AM
On my Beyonwizes, with NETWORK time and the new instructions for the DST changeover from IceTV, I've had the simplest and smoothest DST transition so far!
Yes - I think we've finally cracked it!
Usually I fall into the trap of changng the time manually - which stuffs things up completely
Only transition issue I had this time was some (not all) series seemed to come up with errors - I just deleted the Series and set them up again) - all red dots now!
Quote from: prl on March 31, 2012, 04:33:54 PM
Quote from: bodogbodog on March 31, 2012, 03:26:51 PM
I recieved an email from IceTV at 4.47pm on 30 March 2012 covering the DST implications
You might want to check your junk filter / spam mailbox to see if it's there
I use POP to get my mail and I have spam filtering set to "tag and keep" with my email provider (Yahoo). I checked anyway, and there wasn't anything in my Webmail Spam folder or anything recent from IceTV in my Trash Webmail folder. Occasionally it takes an unreasonable amount of time (more than a day) for messages to get delivered to my inbox.
I still haven't seen any sign of an email about the DST changeover from IceTV. Not in my email provider's webmail spam or deleted folders, either.
I didn't get one either..
Quote from: prl on March 31, 2012, 12:16:58 PM
I haven't received the usual email from IceTV about the upcoming DST change tomorrow 1 April at 03:00.
IceTV has a support item (http://support.icetv.com.au/entries/21199873-daylight-savings-what-do-i-need-to-do-when-daylights-savings-starts-or-ends) about what you need to do about it, for all supported recorders.
Sorry that you did not get the email. Apparently the mail server stopped 1/2 way through and we didn't find out until yesterday. I believe we are resending the email to the remaining 50% of customers.
Hi, Dave. Thanks for the update.
Quote from: Dave at IceTV on April 03, 2012, 12:43:12 PM
...
Sorry that you did not get the email. Apparently the mail server stopped 1/2 way through and we didn't find out until yesterday. I believe we are resending the email to the remaining 50% of customers.
Did the resends get done? I still haven't seen the DST email.
Not sure if it was resent as I still didn't the email either.
You did not miss much. It's the same image as the knowledgebase article with a link to the knowledgebase article, which is here:
http://support.icetv.com.au/entries/21199873
You can see the actual email here:
http://clients.criticalimpact.com/messages/emailshow.cfm?id=34543
I just wondered about whether it had been resent at all, since by the time anyone from IceTV responded in the topic (Apr 3), the DST changeover was past.
Maybe the person who was going to resend it also thought that the DST changeover had passed. Realistically if the customer does nothing then it will sort itself out 5 days after the clock was adjusted. Assuming everyone has recent firmware that automatically adjusted the clock on Sunday then their recordings would be correct from 3am today (Friday) onwards even if they did nothing.
But if they have been manually changing the clock and incorrectly resending their recordings in an attempt to fix the issue they could potentially have their shows record 1 hour out for 5 days from when they last tried to fix it. So even at this point in time it is not too late to follow the steps below if they notice any reservations are set for the wrong time. Personally if only a few reservations have the wrong start time I would manually adjust them and leave the rest alone.
http://support.icetv.com.au/entries/21214507
I got the most recent IceTV What's On In Wollongong This Week OK, so perhaps whatever caused the DST email glitch is fixed.
Me too, but still not the DST email.
It seems that the remaining issue now is that the times for reservations on the PVR (ie already received from ICE prior to the changeover) will be an hour out. I'm not across the complexities of it but given that the ICE system knows this, why cannot it be altered to account for the DST time change and get the reservation times so they become correct after the changeover?
Yes, see my post re all of this here.
http://forum.icetv.com.au/index.php?topic=3366.msg16642#msg16642 (http://forum.icetv.com.au/index.php?topic=3366.msg16642#msg16642)
Quote from: JPP on April 11, 2012, 06:51:11 PM
Yes, see my post re all of this here.
http://forum.icetv.com.au/index.php?topic=3366.msg16642#msg16642 (http://forum.icetv.com.au/index.php?topic=3366.msg16642#msg16642)
The problem seems to originate in the IceTV EPG and timers being in UTC, and many PVRs preferring to work in local time for their timers. This is probably down to the fact that many PVRs run uClinux, and its libraries don't support the zoneinfo database (http://en.wikipedia.org/wiki/Zoneinfo) for time conversion, which does the whole time zone/DST thing properly, so they generally have a whole bunch of horrible time and time zone kludges that make themselves all too evident at DST changeover time.
IMO, it's a mistake to use local time, since in the presence of DST, local time is neither continuous nor unique. :o
There's probably a reason why not that I can't see, but rather than deleting and re-sending the post DST timers and possibly having to worry about setting a view timer, why can't the post DST timers be sent with the correct start time in the first place? There would be a possible issue if a timer straddled the 2am DST time change point but I could live with that in preference to the current arrangement.
I think it's because the timers on the PVR have a different timestamp from the timers on IceTV, and they don't get recognised as being the same timer, and the old timer doesn't get deleted. I recall having duplicated timers like that in an earlier DST transition. This is all on Beyonwiz. Details like this probably vary quite a bit between PVRs. As I said before, the whole UTC/local time thing is a messy kludge.
We are looking at ways to improve, or solve, the Topfield DST changeover issues before DST starts again. But don't stop discussing your ideas.
The mess I've been describing is mostly about the PVRs I know best - Beyonwiz, not Topfield :) However, I suspect the same uClinux issues with time conversion on the Beyonwiz also apply to Topfield.