Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - msimpkins

#1
Hi All,
I have recently upgraded the firmware in my 5492 to version 1.04, and can access ICETV schedules without any drama.  However, I am now getting a problem where the picture blanks for a couple of seconds every few minutes.  I note that this was commented on earlier in this post, but there didn't seem to be anyone offering advice so I thought I would try again.

I have been in contact with Strong, who suggested a replacement box - which I did this weekend.  The problem hasn't gone away though, so I'm starting to get a bit frustrated.  The problem only happens when using the ICETV guide, the standard EPG is fine.

I have suggested to Strong that I will hold out until the next firmware release (which will include padding FYI) and see if that fixes the issue, but if nobody else is suffering from this, surely there must be something wrong with my box or set up.  I am connected to the TV (Panasonic Vierra) using HDMI and to the internet via a CAT5 cable to my router - the ICETV authorisation works okay via the net, and I can see my laptop over the LAN, so I figure that part is ok.

Grateful for any thoughts...

Cheers,
Mark.