Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Sue

#1
I have had an e mail from Strong.

My connections were correct but ......due to new government power regulations for energy the receiver must use less than 1 watt when in standby mode.  Due to this it is unable to pass a signal to the TV.



Either have two products on....Strong box and the TV or use a splitter on the antenna.

Sue 
#2
Thanks Peter.

Is the strong meant to be used as a set top box and therefore on all the time or should i be able to watch my TV in TV mode? 

And yes with my strong in standby mode...blue light showing...I can not watch the TV in TV mode. 

Are there any other settings that I may have missed or that I set incorrectly?

Sue
#3
I have just purchased a strong 5492 HDD "box" but I am not sure if I have connected it correctly as when i turn the box off or to standby I loose the signal on the TV.  The retailer assures me that I should be able to do this.

I have connected the Ariel to the input no. 13 and connected the  TV (HD with own tuner) via out no. 16.  I have then connected the other two with the loop cable.(14 & 15)  service manual page  7.

I can copy etc but if I turn off the strong box, my TV looses the signal. 

Can I connect 13 to Ariel, 14 to TV and loop 14 + 16  and still record 2 or 3 programs ?

As you can tell I am a novice and lost in a world of modern technology.

Sue