I wouldn't have a clue. We don't get Daylight savings in QLD so I am not that much in touch with when it starts and stops.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: wally3218 on October 13, 2008, 05:00:19 PM
Hi guys I've been as frustrated as everyone else trying to get this working I have found a lot of support on the http://forum.itopfield.com.au site This was posted recently.QuoteBluesuede (2008-09-14)
--------------------------------------------------------------------------------
Guys...please remember if you are going to try the beta software..always ALWAYS do a full factory reset after the new firmware is loaded and when doing so have it remove all channel and timer information. Then rescan all services and re-set up your PVR. Wait for the IceTV guide to load before checking LCN mapping (this can take quite a while, so leave it for an hour or so), and ensure you do a "resend all recordings" from the IceTV site if you have timer recordings already set there.
I would not recommend you trial beta firmware if you aren't prepared to set up the PVR from scratch once you've loaded it. And you must always bear in mind that this is not official release firmware, so if you aren't confident with setting everything up and having other potential bugs surface, then please just wait for the final release version.
Cheers
You can get V1.00.19 from http://www.filefactory.com/file/957533/n/1_00_19_upd
I dont know who are more frustrated the users of TF7100 or IceTV staff.
Goodluck,
Wally