Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - merceroz

#1
Topfield / TED/S and ICE and EPGs  
April 24, 2006, 01:33:38 PM
Masterpiece (Firmware 5.12.12)
TED/S 6.3.2.264
PBK 9.8.1
WGT634U wireless router (Firmware 200509071041)

So it's all working great - in fact slightly too well.

As part of its daily run TED uploads the EPG files.  

Despite me telling it not to, the WGT634U still insists on uploading the EPG once a week.  (Not only that it uploads and starts the ICE TAP on the Toppy!)

This seems to confuse the Toppy and gives me a corrupt EPG, until TED next does its thing.

I'm happy with the EPG uploaded by TED (which is the ICE one anyway) and would like to tell the WGT634U not to do anything - other than act as a router between my PC and Toppy.  I've unticked all the days on the WGT634U guide fetch status page, but still it insists on doing it once a week.

Am I missing something?  

Thanks

Gareth
#2
Topfield / Re: All EPG items 2 minutes late
December 02, 2005, 03:26:00 PM
Quote

The guide data gets loaded into the Topfield as UTC and then has the timezone information attached. In manual mode the Topfield does not have an option to set the UTC offset and the way it calculates this is by calculating the time difference between the time that is set and the time that is being sent out through the broadcast.

This means that if the time is out then this is taken into affect. In your case at the moment it means that the time difference between the time on the Topfield is 11 hours and 1 minute (for Sydney, which is currently at +10 UTC) instead of the 11 hours that would make it correct.

Hope this clears it up a bit.

Thanks that makes sense.


#3
Topfield / Re: All EPG items 2 minutes late
November 29, 2005, 09:23:54 PM
I too have the same issue.  But by 1 minute.  I too have the time set to manual.  I've done this because the time broadcast by the networks has the habit of being all over the place - which isn't good for recording.

So why is this an issue?  Why can't I use manual time and display the correct time?

Thanks

Gareth