Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mexiwi

#16
Topfield / Re: Netgear WGT634U
September 24, 2005, 01:15:15 PM
[size=36]SUCCESS!!!!!!!!!![/size]

Thanks peteru

IceBox mkIII is now connected and working.

Set up exactly as you said above

QuoteStart with the AP configured for:
* MAC filtering - OFF
* WEP - 128-bit key in hex
* Broadcast SSID - ON
* DHCP server - ON

Icebox wireless settings:
* Enabled - ON
* ESSID - blank
* WEP key - 128 bit key in hex
* Address - blank (use DHCP)
* Default gateway - blank (obtained via DHCP)
* DNS server - blank (obtained via DHCP)

And worked first time.

The other things I did were:
- Re-downloaded the Ice firmware
- Changed my wireless channel to 1 (was on 6 and neighbour has an open network on 11)
- Turned my neighbours SSID off (tee hee, but they shouldn't have it unsecured)

Now to play with it for a couple of days.
#17
Topfield / Re: Netgear WGT634U
September 20, 2005, 07:21:38 AM
QuoteIf you have hidden SSID, you will have to specify it exactly in the icebox web interface. Keep in mind that the SSID is case sensitive and that it should not have any leading or trailing whitespace. To be on the safe side, keep it to alphanumerics with no spaces or punctuation. Something like "My1stHiddenNetwork" is good, but "My #1 network!" is not the best choice.

Yeah - my SSID was "Brendan's LAN" which worked fine with my laptop, was changed to "BrendanLAN" for the second attempt.

QuoteOnce you configure your wireless network properly, you may end up with both the wired and wireless networks connected at the same time. Depending on the exact setup of your home network, this could present issues related to routing loops. The fix is simple. Wait about 30 seconds, power down the icebox, unplug the wired network and power on the icebox. Wait another 60 seconds, then check the web interface of your AP to see if the icebox is on the network.

I thought that may have been an issue with my first one so the second time I used a direct connection to my laptop which had it's wireless disabled and was isolated from the network.

How long should it take for the unit to succesfully negotiate a connection? At one stage after I changed the settings page it came up with a green band and "associated with network BrendanLAN" but on the status page it said the wireless failed. But that only happened once. Can it take a while for the dhcp to allocate an ip?

I did also try specifying a fixed ip with the second unit via telnet into the DHCP server of my router. But no good so I deleted that.

Quote1. Physical position with respect to the AP.

A lot of the time the unit was sitting beside the AP on my desk when I was trying to set it up. When connected to the toppy it's about 5m away thru a wall.

Might take my laptop out to the lounge and try setup from there with a bit of distance.

Hmm - I can definately see I will be going out and buying yet another one this weekend.

One thing I will do is download the ICE firmware again to make sure that isn't corrupted. How long should a restart of the ICEd unit take, the normal Netgear firmware took a minute or two to initialise, the ICEd one seemed to start within a few seconds (power light goes from yellow to green) - does that sound about right?
#18
Topfield / Re: Netgear WGT634U
September 19, 2005, 07:09:25 PM
QuoteIn your case, the inability to connect to an open network sounds a lot like there may be MAC address filtering enabled on your AP. Of course, it could be any number of other things.

My initial configuration was with MAC filtering enabled, I added the 2 MAC addresses on the bottom of the unit and then during setup I noticed a third MAC address in the status page in the icebox interface so added that too.

My normal network configuration is SSID hidden, MAC filtering on and WPA-PSK.

I had the initial conditions for this one as SSID Hidden, MAC Filtering on with the 3 Icebox associated MACs in there, and "WEP or WPA-PSK" security. WEP kep was the example WEP 128bit HEX just copied straight from my router management page into router and icebox setup page.

After initial failure I went to WEP only on the router.

Next no security on router and deleted the icebox key.

Next MAC filtering off.

Next SSID un-hidden.

Next SSID deleted from icebox.

Next flying lessons.

Shits me that it didn't work but I can see I'm going to end up getting another one and dammit I want it to work.

I'll make sure I skip the flying lessons if I try it again.
#19
Topfield / Re: Netgear WGT634U
September 18, 2005, 04:35:22 PM
QuoteSome anger management required? ???

Quite possibly, I once had a PS2 fail in similar circumstances during a GT3 licence test, I bought a wheel with the neaxt PS2 and it didn't break once.

QuoteEven if mine failed I would have asked for some advice before breaking it.

Yeah - but I'd already been thru all the suggestions made when my first one bricked. I couldn't even get it connecting to an open network, that smacks of incompatibility and I was mighty pissed off.
#20
Topfield / Re: Netgear WGT634U
September 18, 2005, 08:48:03 AM
QuoteIf you'd like to send us the Netgear we can test it for you at no charge.  If there is a problem with our firmware we'd like to see what it is.

That would have been good but unfortunately the unit has been put to death. Now residing in my wheelie bin in a number of bits.
#21
Topfield / Re: Netgear WGT634U
September 17, 2005, 09:21:59 PM
This is not a good solution I was unable to make it work with my wireless network.

I originally bought a refurbished WGT634U off eBay, flashed the ICE firmware okay but it bricked on me without ever working, probably due to bad flash memory - my punt on eBay.

Bought a new Aus unit and flashed the firmware and it never once connected to my wireless network, I was able to plug it into my laptop LAN port and change the wireless settings to no avail, WEP or no WEP, SSID or not. I opened my network completely, SSID not hidden, no MAC access control, no security - no WEP key in ICE setup, SSID and no SSID specified, nothing. If a product won't connect to an open network then it must be flawed.

Nice try but please wake me when there is a decent product available - lucky I only got a Trial ICE membership.
#22
Topfield / Re: IceBox Enhancement Wishlist
August 09, 2005, 11:04:50 AM
QuoteThanks for the feedback Peter.

WEP offers very weak security.

Agree, I use WPA on my WLAN and would like to be able to connect one of the wireless thingos to my Toppy & WLAN

Another addition to the wishlist is a 3min skip - I've been using the ProgressBarKeys TAP for ages and love the 3min skip for ads, one press, no ads - It's on the Red button.
#23
Topfield / Re: Netgear WGT634U
August 09, 2005, 10:59:36 AM
Another question about the WGT634U, as I would like to add it to my wireles network at home with my Toppy, does it support WPA wireless encryption over 802.11g?