I switched the TV on earlier and in the TV tab there was a message...PVR manager is starting up 0%
I checked on this forum and as suggested i tried a soft reset, no change, i tried a hard reset still no change. i checked the system screen and there is no IP address showing.
With either the soft or hard reset it didn't go into a full install and config.
When the last screen appears and asked you to wait 30 seconds for the setup to continue, nothing else happens, If i go into the TV tab the PVR Manager message is still going around.
I thought a hard reset would have taken the system back to a blank insatll and i would have to do a channel scan etc
Any suggestions on what the solution may be
I checked on this forum and as suggested i tried a soft reset, no change, i tried a hard reset still no change. i checked the system screen and there is no IP address showing.
With either the soft or hard reset it didn't go into a full install and config.
When the last screen appears and asked you to wait 30 seconds for the setup to continue, nothing else happens, If i go into the TV tab the PVR Manager message is still going around.
I thought a hard reset would have taken the system back to a blank insatll and i would have to do a channel scan etc
Any suggestions on what the solution may be