Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - martpc

#1
Getting Help / Re: Setting end padding to 15 minutes
February 14, 2023, 04:12:53 PM
While looking at the add-ons-services-IceTV-Configure I found a Pre-Padding and Post-Padding entries that were both set to 0.  I do not know the inter-relationship between this IceTV Kodi Add-on and the Kodi program so I am a little bit scared of experimenting with what is basically a black box to me ie no documentation to the Add-on functionality to Kodi.  If I brick the IceBox is that covered by warranty?
#2
ICEBox looses sound for no apparent reason.  The device is not muted, volume set to high. Using the HDMI furthest from the power input.  No manual was supplied for the Reyfoon TD6 so I have no idea which is the primary HDMI.  I tried the other one but it resulted in a very flickering image on screen. Reboots make no difference to sound.  Anyone have any ideas?
#3
If you have issues finding the settings you need to do a specific task on a menu, go down to the bottom of the menu and click on the User setting (Basic, Standard (default), Advanced and Expert) to see if there are any elevated option menus.  This is the case on the KODI Interface menu when you want to setup the regional date/time setting correctly.
#4
Getting Help / Re: SETTING UP MY NEW ICETV UNIT
January 24, 2023, 05:05:22 PM
When setting up the ICEBox you can use the following URL at IceTV for the basic steps.

https://support.icetv.com.au/hc/en-us/sections/5888216109455-General

You may have also got an email from the ICEBox support team to make sure you wait at a screen to ensure that a software download happens.

When the box is switched on the IceTV Wizard will automatically run BUT WAIT on the last setup screen after internet connection and SSH and SMB services. (Wifi setup if used is done by scrolling up and selecting the wifi channel you wish to use.  An Ethernet connection should show up automatically as an IP address). Then the setup will go to SMB or SSH services.  STOP-

 

-AT THIS POINT DON'T PRESS NEXT and simply wait at least two minutes as the software update is downloading.  Unfortunately no message confirms the update but two minutes is ample time.

 

Then press NEXT and the IceTV Wizard will ask for your IceTV email address and password and the Wizard will scan the same channels as you have in your IceTV account and download the EPG.

 

All should be good to go now. Remember that you can copy the recording settings you have on another PVR onto your IceBox by going to your IceTV account and going to "My Recorders" where there is a tab to copy recording settings from one PVR to another.