Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - dinym

#1
SKIPPA / Re: Keeps freezing up when using the remote
October 05, 2015, 05:17:11 PM
IceTV have advised me that this slow response plus the fact that my unit couldn't record  then got stuck in an endless boot loop when I did a factory reset is a known HARDWARE problem and they are replacing my unit :)
#2
SKIPPA / Re: Error Code 10 at boot
October 05, 2015, 05:00:35 PM
An update. I also tried doing a factory reset but the unit got stuck in an endless reboot cycle each time it completed "Activating Autoskip".
IceTV say that this is a hardware problem and are replacing the unit  :D

#3
SKIPPA / Re: Error Code 10 at boot
October 04, 2015, 11:28:56 PM
Thanks Dave,
Yes you are right, that was the channel 10!
So I had reboxed my SKIPPA and put it away for an hour. Then decided to recheck. Now it started up okay and seems to be responding, i.e. can see Video and so far the response time is good. Previously nothing showed up on the TV when it restarted.

I think that the problem was that when it hung, I pulled out the power and plugged it in again after about 5 seconds. I suspect that this may have affected the restarts as the only change was that it was unplugged from power for an hour.
Hopefully it keeps functioning. Haven't been able to trigger a recording yet but will wait for Tuesdays update.

Thanks for your input. It prompted me to try again!

[UPDATE 05/10/2015: IceTV say this is a hardware issue and are replacing the unit]
#4
SKIPPA / Error Code 10 at boot
October 04, 2015, 09:41:48 PM
After successful unboxing and initial set-up including about 10 series recordings, within an hour I was struggling with erratic response times to any button presses from both remote and directly on the unit. Response times ranged from nanoseconds to over 5 minutes. I restarted the unit and applied the latest upgrade - no improvement. So unplugged and restarted the unit. It rebooted to an error code 10 with No Video. unplugged, waited for 20 min and tried again, still error 10 and no output. Have raised an issue within my IceTV Acc and await my next instructions. Has anyone here experienced the same issue?