How to get custom padding back after firmware update.

Started by IanL-S, February 23, 2023, 08:48:05 AM

Previous topic - Next topic

IanL-S

This can be done as follows.

FIRST: Create a dummy device in you IceTV account, rename it Dummy (or some other helpful name). This is done in My Account, Recorders.

SECOND: Copy the timers from IceBox to Dummy (done in My Account, Recorders - then move to the Copy timers to new recorder).

THIRD: Power down the IceBox

FOURTH: In My Account, My Recorders, delete the IceBox

FIFTH: Power-up the IceBox, it will then go through the setup wizard.

SIXTH: Go into TVheadend configuration - http://{your IcBox IP address}:9981/ then select Recording, Digital Recording Profile, and then selct IceTV profile, change the pre- and post-padding to the desired amount. Also check that "Use Windows-compatible filenames" is slected; then click on save.
IceTV IceBox defaults c.png

SEVENTH: Copy the timers from dummy device to the IceBox.
IceTV: IceBox + BYOB IceBox + 2xTRF-2400 + 2xTF7100HDPVRtPlus + SKIPPA [RIP] + T2 + U4 + V2
No IceTV: a few Toppys and T2
Synology NAS
Check out the oztoppy wiki and oztoppy Forum for Toppy help