Author Topic: Can not record future progs from IceTV EPG  (Read 912 times)

Offline bluntaxe

  • Newbie
  • *
  • Posts: 1
    • View Profile
Can not record future progs from IceTV EPG
« on: February 07, 2016, 09:41:15 PM »
Previously could press enter twice on Topfield remote control to record any future program but since a Topfield update this does not work.. Press once and a "P" comes up press again and instead of a "R" it clears the "P"

Offline IanL-S

  • Guru
  • *****
  • Posts: 982
    • View Profile
    • IceTV SKIPPA wiki
Re: Can not record future progs from IceTV EPG
« Reply #1 on: February 08, 2016, 05:22:16 PM »
This probably has nothing to do with the firmware update. Fortunately, there is a simple solution (assuming it is the problem I have from time to time).

What you need to do is to reset services (Menu, Installation, System Recovery, Reset Service List). You then do a new service scan (Menu, Installation, System Recovery, Searching). You will then have to set up IceTV on the Toppy and resend all you timers from the IceTV interactive www site; you do this in My Account section, click on the My Recorders and then click on the Settings Button for the particular recorder, and click on resend all recordings for this device.

IceTV: 2xTRF-2400 + 2xTF7100HDPVRt + SKIPPA + T2
No IceTV: a few Toppys
Synology NAS
Check out the oztoppy wiki and Topfield Aus Forum for Toppy help
ozSKIPPA wiki coming soon (I hope)

Share via facebook Share via twitter

Prime 7HD (Canberra) - TBA

Started by vader1111 on IceTV EPG Content

1 Replies
Last post February 01, 2019, 12:53:30 PM
by Tiphanee
The Americans

Started by prl on General Discussions

4 Replies
Last post December 23, 2018, 07:31:15 PM
by prl
Cannot log into new www site with Chrome but can with Edge

Started by IanL-S on Smart Recording website and General questions

11 Replies
Last post December 08, 2018, 01:46:18 PM
by prl
Can not retrieve channel map: The IceTV server can not be reached

Started by raymondjpg on Beyonwiz

6 Replies
Last post November 03, 2018, 04:07:15 PM
by raymondjpg