IceTV Forum

IceTV Guide for IceTV enabled PVRs => Beyonwiz => Topic started by: GeoffU on September 23, 2017, 08:30:35 AM

Title: Picture too big - overscanning T2
Post by: GeoffU on September 23, 2017, 08:30:35 AM
Refreshed the firmware on the T2 because there was no audio on 7Flix.  Worked ok :)
Now the picture on my TV is overscanned. That is, the edges of the picture are cut off by, say 5%. (Previously it was OK.)

Think it is the Beyonwiz ‘cos the TV settings were not changed. And the direct TV input is OK.

Would really appreciate help on this one. Thanks!
Title: Re: Picture too big - overscanning T2
Post by: grumpy_geoff on September 23, 2017, 10:58:37 AM
Turn off the overscan setting in your TV (it may be referred to as dot-by-dot, just-scan, per-pixel, or similar).
If you've an old TV that doesn't have that setting, adjust the T-series GUI via MENU->Setup->AV Setup->OSD position
Title: Re: Picture too big - overscanning T2
Post by: prl on September 23, 2017, 12:20:39 PM
Older firmware assumed that all TVs overscanned. Newer firmware assumes that TVs don't overscan.