Incorrect logos on certain channels - Emby Premiere with Hauppauge tuner

Started by dale_mac, October 16, 2018, 08:04:02 PM

Previous topic - Next topic

dale_mac

Hi all,

I've just set up my TV guide on Emby Premiere and using a Hauppauge HVR2200 TV tuner on my Windows 10 PC. Everything works okay, but the logos for a couple of channels in the guide are wrong.
Ten's channel ONE, which is mapped to 12, shows the channel 7 logo.
Ten's channel TEN HD, which is mapped to 13, shows the channel 9 logo.
These are Brisbane channels.
I'm not worried about the one on channel 12, as I can delete it within the Hauppauge software.
ONE is also mapped to 1, so I can use that.
I'm only interested in fixing the channel 13.
I've refreshed the guide, but it doesn't help.
Any clues? Will I have to delete the tuner and start again?
Windows 7 Media Centre
Kodi

Daniel Hall at IceTV

Hi dale_mac,

While the logo is showing incorrect on those channels, when going into the guide does the guide data show the correct listings for that channel?
Regards,

Daniel.
CTO.

dale_mac

Hi Daniel,
The data is correct for the channels, it's only the logo that's wrong.
Cheers,
Windows 7 Media Centre
Kodi

dale_mac

Windows 7 Media Centre
Kodi

Daniel Hall at IceTV

Hi dale_mac,

Sorry for the delay on this one. While going through some of the changes today for 10, Peach and Boss I was able to have a look at the feed you are getting and can confirm that the images being sent to your Emby setup are correct. It would also look like the channel mappings are correct though as otherwise the guide data would be incorrect.

When I last did a setup within Emby (without premiere) I ended up with the screenshot at the bottom of our support article at https://support.icetv.com.au/hc/en-us/articles/360000174136-Setting-up-IceTV-XMLTV-in-Emby which has the channel logos correct.
Regards,

Daniel.
CTO.