I've managed to get my Ice router to use the wired and wireless interfaces simultaneously and to route between them.
I'm now running my Xbox on the wired segment, and using the wireless interface to route back to my access point and the remainder of my home network.
Eth0 on the router is where the Xbox is connected, and it can now reach the internet over the same router that the Toppy updates its EPG from.
I'm not sure what the state of the hub/switch ports on the back of the unit are at the moment, or whether I can activate them. I will investigate further and report back.
The underlying Ice router linux distro isn't too hard to navigate or "adjust".
Shouldn't be too long before someone puts together a page that allows you to tweak the IP forwarding, as well as wireless settings and routing table to give you a lot more control over these routers.
I'm now running my Xbox on the wired segment, and using the wireless interface to route back to my access point and the remainder of my home network.
Eth0 on the router is where the Xbox is connected, and it can now reach the internet over the same router that the Toppy updates its EPG from.
I'm not sure what the state of the hub/switch ports on the back of the unit are at the moment, or whether I can activate them. I will investigate further and report back.
The underlying Ice router linux distro isn't too hard to navigate or "adjust".
Shouldn't be too long before someone puts together a page that allows you to tweak the IP forwarding, as well as wireless settings and routing table to give you a lot more control over these routers.